Lemke Software GmbH Forum

<t>I just read the document "CADintosh Introduction.pdf" and there on page 5 it explains a little about these buttons. It reads:"You define the catch mode with the four boxes 11 to 14 on the right. Click the right-hand box of the four (14) if it has not been selected yet."They are referring to the f...

<t>Thanks Rowland. I tried what you suggested. and it worked! Many thanks!!! I wondered what these icons represented. I searched the manual and found on page 8 at the bottom the following:2.1.28 Selection ModeThere are three selection modes:1. Freehand/Snap to Grid ( ) - The selection point will be ...

<t>I have a question dealing with constraining element endpoints to snap to a grid or to another close element. What I am finding is that when moving elements by selecting a reference point with the cursor, I can get very close to my desired location, but still off by a few hundredths of an inch. I ...

Thanks Keith. Actually I went there are there are 276 messages. I tried to join the group but it has been a few days now and my membership is still "pending." How long should it take to be approved to join this group?

<t>Hi. Newbie here. Is this a forum for users of CADintosh users too? I did a search on the word but no results (but I also read that the searches do not work in this group ... :~( Anyway, if this group does contain CADintosh users, here is my question: How do you group elements into a single object...