Lemke Software GmbH Forum

Thank you, it works fine.
Bon

Dear Thorsten, My post is not understandable well, I guess. With the "Dimension Parallel" command, defined "Witness-Extension" is shown or not according to its position. See the attached PDF. I could not check DIN406 because of the price, however, I presume the regulation gives t...

Hi, I have noticed following recently. If I write a dimension using "Dimension Parallel" command, "Witness-Extension" is zero depending the orientation(angle) of the object. This phenomenon is observed on "Dimension Diameter" command too. See attached PDF. Version: CADi...