Dimension problem

This area contains the messages from the old Yahoo cadintoshmac group after the port.
Post Reply
jroshima@aol.com
Posts: 0
Joined: Sun Feb 27, 2005 11:59 pm

Dimension problem

Post by jroshima@aol.com »

Hello:When the program makes dimensions, it draws a line with arrow points at each end. At times, the points are "inside" the two lines being dimensioned, pointing outwards. At other times (more often) the points are "outside" the two lines, and are pointing in towards the center of the line. How do you control this difference? I've tried "Option > Dimenions" and the Line Ending menu at the bottom of the drawing. Thanks, Jon
Post Reply