scaling for printing

This area contains the messages from the old Yahoo cadintoshmac group after the port.
Post Reply
RowlandCarson
Posts: 2
Joined: Fri Dec 30, 2016 10:56 am

scaling for printing

Post by RowlandCarson »

Thorsten - I submitted to you on 12 November 2014 a sample drawing that I was having trouble scaling for printing. I can’t see a specific response to that issue yet.I haven’t been using CADintosh much recently and so have not had the opportunity to report bugs etc but yesterday I tried to print a drawing that I had created in an earlier version of CADintosh. As I had printed it (a long time) before, I didn’t bother with page setup or scaling etc but the result was that it printed on 176 pages of A4 instead of the single page I expected! (As I was printing to PDF, it was not a waste of paper!). I checked the scaling of the area I was printing and found it was a strange used-defined value (see attached screenshot). However, even after changing that to 1:1 the result when I tried to print was the same. I can e-mail you the drawing for analysis if that helps.in friendshipRowland: Rowland Carson          ... that's Rowland with a 'w' ...: <rowlandcarson@gmail.com>            http://www.rowlandcarson.org.uk: Skype, Twitter: rowland_carson      Facebook: Rowland Carson: pictures: http://picasaweb.google.com/rowlandcarson
Post Reply