[Solved] Auto-update does not finish

Having tech problems? Post them here and do not worry, there is always a solution for you.
Post Reply
prasm
Posts: 8
Joined: Fri Dec 30, 2016 11:13 am
Location: Reykjavík, Iceland

[Solved] Auto-update does not finish

Post by prasm »

I opened my GC 10.3 today and I noticed that the „Check for updates“ was dimmed which usually means that there is an update going on. Then nothing happened in about an hour. I used Quit and got an message that an update was going on from the updater. I asked for Quit anyway. Then I got a message from updater that it needed my password to install the new version. I did and the new version vas installed.

This has happened before: The updater puts on Wait after download instead of asking for permission. I would be nice to have this fixed.

Best regards
Pétur
--------------------------------------------------------
Pétur Rasmussen e-mail: prasm@internet.is
Sólheimum 23, 7A Tlf.: +354-553 2858
IS-104 Reykjavík Mobil: +354-822 0645
User avatar
forum_adm
Site Admin
Posts: 1814
Joined: Fri Dec 23, 2016 9:41 am
Location: Germany
Country: Germany
Contact:

Re: Auto-update does not finish

Post by forum_adm »

Dear Pétur,
this does normally indicate a dropped internet connection or a failure in the Sparkle update framework.
Just quit GraphicConverter and retry or download the update directly from our web server.
Thorsten
Post Reply