I opened my GC 10.3 today and I noticed that the „Check for updates“ was dimmed which usually means that there is an update going on. Then nothing happened in about an hour. I used Quit and got an message that an update was going on from the updater. I asked for Quit anyway. Then I got a message from updater that it needed my password to install the new version. I did and the new version vas installed.
This has happened before: The updater puts on Wait after download instead of asking for permission. I would be nice to have this fixed.
Best regards
Pétur
[Solved] Auto-update does not finish
[Solved] Auto-update does not finish
--------------------------------------------------------
Pétur Rasmussen e-mail: prasm@internet.is
Sólheimum 23, 7A Tlf.: +354-553 2858
IS-104 Reykjavík Mobil: +354-822 0645
Pétur Rasmussen e-mail: prasm@internet.is
Sólheimum 23, 7A Tlf.: +354-553 2858
IS-104 Reykjavík Mobil: +354-822 0645
- forum_adm
- Site Admin
- Posts: 1819
- Joined: Fri Dec 23, 2016 9:41 am
- Location: Germany
- Country: Germany
- Contact:
Re: Auto-update does not finish
Dear Pétur,
this does normally indicate a dropped internet connection or a failure in the Sparkle update framework.
Just quit GraphicConverter and retry or download the update directly from our web server.
Thorsten
this does normally indicate a dropped internet connection or a failure in the Sparkle update framework.
Just quit GraphicConverter and retry or download the update directly from our web server.
Thorsten