[Solved] Getting started with CAD
Posted: Fri Nov 23, 2018 4:47 pm
I am interested in learning to use CADintosh and not sure where to begin. Some of my basic questions are: When drawing a floor plan I create my room size and then I want to represent inside walls with parallel lines. How do I tell CADintosh to draw the parallel line for my right hand wall inside or to the left instead of outside to the right without having to calculate the distance from the far left hand wall? Or if I am drawing door swings and one swings in from the left and another swings in from the right or swings out. How do I tell CADintosh the direction of the swing arc?
I don't want to post basic questions like this each time I have one. So I am looking for resources to actually learn to use CAD that will cover this type of basics.
Any suggestions greatly appreciated.
I don't want to post basic questions like this each time I have one. So I am looking for resources to actually learn to use CAD that will cover this type of basics.
Any suggestions greatly appreciated.