Page 1 of 1

[Solved] Dimension-Parallel issue?

Posted: Sun Dec 31, 2017 8:51 am
by BonOhsato
Hi,
I have noticed following recently.

If I write a dimension using "Dimension Parallel" command, "Witness-Extension" is zero depending the orientation(angle) of the object.
This phenomenon is observed on "Dimension Diameter" command too.
See attached PDF.

Version: CADintosh 8.3 (Build 338), 8.3.2(Build 348)

Check it out, Bitte.

Re: Dimension-Parallel issue?

Posted: Fri Jan 05, 2018 9:26 pm
by forum_adm
Dear Bon,

the orientation of the dimension is according German standard DIN 406.

Thorsten

Re: [Closed] Dimension-Parallel issue?

Posted: Tue Jan 09, 2018 2:38 pm
by BonOhsato
Dear Thorsten,

My post is not understandable well, I guess.

With the "Dimension Parallel" command, defined "Witness-Extension" is shown or not according to its position.
See the attached PDF.

I could not check DIN406 because of the price, however, I presume the regulation gives the writing direction of the letters of the dimension, not the "Witness-Extension".

Thanks for your attention,
Bon

Re: Dimension-Parallel issue?

Posted: Wed Jan 10, 2018 7:14 pm
by forum_adm
Thanks. We will recheck this.

Re: Dimension-Parallel issue?

Posted: Sat Jan 27, 2018 8:48 am
by forum_adm
We found and fixed the issue.

Please download the latest BETA and recheck yourself:
http://www.lemkesoft.org/beta.html

Thorsten

Re: [Solved] Dimension-Parallel issue?

Posted: Sat Jan 27, 2018 11:57 am
by BonOhsato
Thank you, it works fine.
Bon