[Solved] Hatching or other fills

Having tech problems? Post them here and do not worry, there is always a solution for you.
Post Reply
WCraig
Posts: 8
Joined: Fri Feb 15, 2019 5:22 pm
Country: Canada

[Solved] Hatching or other fills

Post by WCraig »

Hi:

I can't seem to figure out how to control hatching or other fills properly. Say I'm drawing a simple rod that is threaded on either end and has an unthreaded section in the middle. I drew the outline of the threaded rod with a polyline and then added lines to delineate the threaded and unthreaded portions. However, when I applied hatching, it went across the whole initial polyline. I tried to split the polyline but don't think I did that successfully.

Craig
User avatar
forum_adm
Site Admin
Posts: 1814
Joined: Fri Dec 23, 2016 9:41 am
Location: Germany
Country: Germany
Contact:

Re: Hatching or other fills

Post by forum_adm »

Hi Craig,

hatching/fill is currently designed for elements surrounded by arcs, circles and lines.
Just explode a poly line if you want to use it as a border.

You can e-mail a sample file zipped to support@lemkesoft.de
I will make a short tutorial movie.

Thorsten
Post Reply