[Solved] Hatching or other fills
Posted: Wed Mar 27, 2019 9:19 pm
Hi:
I can't seem to figure out how to control hatching or other fills properly. Say I'm drawing a simple rod that is threaded on either end and has an unthreaded section in the middle. I drew the outline of the threaded rod with a polyline and then added lines to delineate the threaded and unthreaded portions. However, when I applied hatching, it went across the whole initial polyline. I tried to split the polyline but don't think I did that successfully.
Craig
I can't seem to figure out how to control hatching or other fills properly. Say I'm drawing a simple rod that is threaded on either end and has an unthreaded section in the middle. I drew the outline of the threaded rod with a polyline and then added lines to delineate the threaded and unthreaded portions. However, when I applied hatching, it went across the whole initial polyline. I tried to split the polyline but don't think I did that successfully.
Craig