GC 9 won't trim after rotating
GC 9 won't trim after rotating
One of my favorite features, trim white space after rotating, no longer works. Using GC9. I used to be able to use Command-Option-4 to rotate with a line, and the white space around the edges would go away automatically and immediately. Not on save even, though that is also not working.
-
- Posts: 0
- Joined: Fri Dec 30, 2016 12:00 pm
Re: GC 9 won't trim after rotating
Hi,did you check the option for this?ThorstenOn 17.02.2014, at 18:56, <buzzwig@yahoo.com> <buzzwig@yahoo.com> wrote: One of my favorite features, trim white space after rotating, no longer works. Using GC9. I used to be able to use Command-Option-4 to rotate with a line, and the white space around the edges would go away automatically and immediately. Not on save even, though that is also not working.
Re: GC 9 won't trim after rotating
I have been searching for months and cannot find the option for it.
Re: GC 9 won't trim after rotating
OK, I found it in the "Other value..." submenu of the "Rotate" submenu. I thought I had looked there, but apparently I had not.~b