[Added] Circular gradations

Having tech problems? Post them here and do not worry, there is always a solution for you.
WCraig
Posts: 8
Joined: Fri Feb 15, 2019 5:22 pm
Country: Canada

[Added] Circular gradations

Post by WCraig »

Hi:

Is there an efficient way to draw something like the following in CADintosh?
Dial indicator face 1635284553191.jpg
Dial indicator face 1635284553191.jpg (73.9 KiB) Viewed 756 times
I see that the 'Line at an angle tool' can draw from the centre to the rim and then with another circle I could trim the major and minor tick marks to the correct length. Is there some way to replicate the ticks around the perimeter? Otherwise, it is very tedious.

Also, is there a good way to place the number values relative to the ticks (ie "40" in the 'south' position)?

The goal is to be able to print a high-res label to go over a damaged dial face.

Thanks,

Craig
User avatar
forum_adm
Site Admin
Posts: 1714
Joined: Fri Dec 23, 2016 9:41 am
Location: Germany
Country: Germany

Re: Circular gradations

Post by forum_adm »

I added it to the latest BETA 697:
http://www.lemkesoft.org/beta.html

Thorsten
Screenshot 2023-08-12 at 11.04.24.jpg
Screenshot 2023-08-12 at 11.04.24.jpg (51.49 KiB) Viewed 322 times
Screenshot 2023-08-12 at 11.04.16.jpg
Screenshot 2023-08-12 at 11.04.16.jpg (96.41 KiB) Viewed 322 times
Screenshot 2023-08-12 at 11.04.10.jpg
Screenshot 2023-08-12 at 11.04.10.jpg (101.37 KiB) Viewed 322 times