Hi,
I have noticed following recently.
If I write a dimension using "Dimension Parallel" command, "Witness-Extension" is zero depending the orientation(angle) of the object.
This phenomenon is observed on "Dimension Diameter" command too.
See attached PDF.
Version: CADintosh 8.3 (Build 338), 8.3.2(Build 348)
Check it out, Bitte.
[Solved] Dimension-Parallel issue?
[Solved] Dimension-Parallel issue?
- Attachments
-
- dimension-parallel-issue.jpg (30.07 KiB) Viewed 6383 times
- forum_adm
- Site Admin
- Posts: 1819
- Joined: Fri Dec 23, 2016 9:41 am
- Location: Germany
- Country: Germany
- Contact:
Re: Dimension-Parallel issue?
Dear Bon,
the orientation of the dimension is according German standard DIN 406.
Thorsten
the orientation of the dimension is according German standard DIN 406.
Thorsten
Re: [Closed] Dimension-Parallel issue?
Dear Thorsten,
My post is not understandable well, I guess.
With the "Dimension Parallel" command, defined "Witness-Extension" is shown or not according to its position.
See the attached PDF.
I could not check DIN406 because of the price, however, I presume the regulation gives the writing direction of the letters of the dimension, not the "Witness-Extension".
Thanks for your attention,
Bon
My post is not understandable well, I guess.
With the "Dimension Parallel" command, defined "Witness-Extension" is shown or not according to its position.
See the attached PDF.
I could not check DIN406 because of the price, however, I presume the regulation gives the writing direction of the letters of the dimension, not the "Witness-Extension".
Thanks for your attention,
Bon
- Attachments
-
- Witness-Extension.jpg (28.26 KiB) Viewed 6348 times
- forum_adm
- Site Admin
- Posts: 1819
- Joined: Fri Dec 23, 2016 9:41 am
- Location: Germany
- Country: Germany
- Contact:
Re: Dimension-Parallel issue?
Thanks. We will recheck this.
- forum_adm
- Site Admin
- Posts: 1819
- Joined: Fri Dec 23, 2016 9:41 am
- Location: Germany
- Country: Germany
- Contact:
Re: Dimension-Parallel issue?
We found and fixed the issue.
Please download the latest BETA and recheck yourself:
http://www.lemkesoft.org/beta.html
Thorsten
Please download the latest BETA and recheck yourself:
http://www.lemkesoft.org/beta.html
Thorsten
Re: [Solved] Dimension-Parallel issue?
Thank you, it works fine.
Bon
Bon