Lemke Software GmbH Forum

Hello,I use the following settings:Parameter - Drawing: A4 verticalFile - Page Format - Standard: A4 verticalIf I define an area via "define with page" this area is clearly smaller than the defined page.I figured that if both, drawing and page is set to A4 that the corresponding area defined by the page should have exactly the same size.What do I do wrong?

Attachments :Re: [cadintoshmac] Problem with page size and printing Hello,The print area shows normally the printable area.ThorstenVon: "bernd.bieker" <sb@berndbieker.de>Antworten an: <cadintoshmac@yahoogroups.com>Datum: Sat, 21 Feb 2009 08:48:19 -0000An: <cadintoshmac@yahoogroups.com>Betreff: [cadintoshmac] Problem with page size and printing  Hello,I use the following settings:Parameter - Drawing: A4 verticalFile - Page Format - Standard: A4 verticalIf I define an area via "define with page" this area is clearly smaller than the defined page.I figured that if both, drawing and page is set to A4 that the corresponding area defined by the page should have exactly the same size.What do I do wrong?            .