Most of the tools have number setting boxes that are too small to read in Graphic Converter v11 (4003). As a result, the intended ability for fine tuning is lost. Here is what I have found:
1) Eraser has its setting cut off after two digits and the decimal point. In the screenshots attached:
'Eraser number is cut off (a).png' demonstrates how the numbers past the decimal are lost for the top setting.
- Eraser number is cut off (a).png (53.65 KiB) Viewed 3866 times
- Eraser number is cut off (b).png (58.07 KiB) Viewed 3866 times
- Stamp number is cut off.png (54.23 KiB) Viewed 3866 times
[The board interface refused to attach further images]
4) Magic Pen has the same again, as seen in the screenshot attached: 'Magic Pen number is cut off.png'.
[The board interface refused to attach further images]
5) Eyedropper has the same again, as seen in the screenshot attached: 'Eyedropper number is cut off.png'.
[The board interface refused to attach further images]
The other tools with settings number boxes are fine, from my observations, for the numbers they hold.
Please enlarge all of these boxes in order to allow observation of their precise settings.
Thank you!
[I'll attempt to attach the refused images in a reply post. If that fails, I'll hang onto them for a brief time, available upon request via email, etc.]
