Page 1 of 1
Opening files from old version
Posted: Sun Apr 14, 2013 9:00 pm
by outcast01
So, Ive been useing CADintosh for a long time. The last version I was running was CADintosh 7 on my old G5 mac. The problem I am having is every time I open an old file all my tools settings are reset. Lines are set to infinite, parallel lines automaticly go to the side my curser is on. I have to go and change all my tools preferances on all my files FOR EACH FILE! Is there some bug about opening old files are am I missing something?
Re: Opening files from old version
Posted: Sun Apr 14, 2013 9:37 pm
by thorstenlemke
Hello,can I please get one drawing?Thorsten On 14.04.2013, at 20:00, "outcast01" <
outcastzeroone@yahoo.com> wrote: So, Ive been useing CADintosh for a long time. The last version I was running was CADintosh 7 on my old G5 mac. The problem I am having is every time I open an old file all my tools settings are reset. Lines are set to infinite, parallel lines automaticly go to the side my curser is on. I have to go and change all my tools preferances on all my files FOR EACH FILE! Is there some bug about opening old files are am I missing something?