[Added] Circular gradations

[WCraig]

Hi:

Is there an efficient way to draw something like the following in CADintosh?

Dial indicator face 1635284553191.jpg (73.9 KiB) Viewed 753 times

I see that the 'Line at an angle tool' can draw from the centre to the rim and then with another circle I could trim the major and minor tick marks to the correct length. Is there some way to replicate the ticks around the perimeter? Otherwise, it is very tedious.

Also, is there a good way to place the number values relative to the ticks (ie "40" in the 'south' position)?

The goal is to be able to print a high-res label to go over a damaged dial face.

Thanks,

Craig

[forum_adm]

I added it to the latest BETA 697:
http://www.lemkesoft.org/beta.html

Thorsten

Screenshot 2023-08-12 at 11.04.24.jpg (51.49 KiB) Viewed 319 times

Screenshot 2023-08-12 at 11.04.16.jpg (96.41 KiB) Viewed 319 times

Screenshot 2023-08-12 at 11.04.10.jpg (101.37 KiB) Viewed 319 times