Lemke Software GmbH Forum

It's hard to guess the correct radius that would match the radius of an actual picture without any preview, I currently have to enter a number, confirm, undo, invoke the command again, adjust the number, which is cumbersome
Would you please add a preview so that changing the radius number would show immediately what the result would be after applying the function?

Please download build 5719. I added a preview:

Thanks! Would it be possible to also add a rectangle on the actual picture so that you can see in which area your picture is off the rectangle for which GC is cutting the corners
You can clearly see that the corners are misaligned in your nice blow up of the 4 corners, but at the same time it's not obvious how you should move your picture for the corners to be perfectly aligned

This function is always applied to the complete image.

Ah, sorry, I confused it with a nonexisting feature where you could make the frame from an arbitrary rectangle :) (e.g., if you have several cards in the same image you could only cut the corners from a single one without having to move each into a separate image)
But yeah, for a Frame effect it makes sense to be applied to the whole frame.

Cool new feature!