[Solved] How to quickly toggle Size from Center, Draw from Center?

The right place to speak and share about your experiences of GraphicConverter
Post Reply
jdmsigma
Posts: 4
Joined: Tue Nov 02, 2021 3:02 am
Country: Canada

[Solved] How to quickly toggle Size from Center, Draw from Center?

Post by jdmsigma »

Is there a quick way to toggle the Size from Center / Draw from Center option for a tool?

I presume there is, but don't see a menu item to do this nor see it in the manual for GC10 nor in a forum search.

In my current task I'm repeatedly switching this off in the selection tool, then on in the circle drawing tool, so it would be helpful if this setting could be made (optionally) per tool rather than global, but I expect a global toggle is normally preferable.

Or perhaps a modifier key to change the behaviour for one time use.

Apologies if I'm missing something obvious.

Thanks for advice/suggestions/education and a wonderful application!
User avatar
forum_adm
Site Admin
Posts: 1812
Joined: Fri Dec 23, 2016 9:41 am
Location: Germany
Country: Germany
Contact:

Re: How to quickly toggle Size from Center, Draw from Center?

Post by forum_adm »

You find a menu command in the Window menu of GC11 and GC12. So, you can assign a shortcut.
Screenshot 2023-09-20 at 07.05.29.jpg
Screenshot 2023-09-20 at 07.05.29.jpg (87.15 KiB) Viewed 752 times
Post Reply